Search for: All records

This study demonstrates a substantial enhancement of breakdown voltage in β-Ga2O3 Schottky barrier diodes through an approach that combines fast neutron irradiation with controlled post-irradiation electro-thermal annealing. Devices irradiated with 1 MeV neutrons at a high fluence of 1 × 1015 n/cm2 initially exhibited substantial degradation, including a drastic reduction in on-current and an increase in on-resistance. Electro-thermal testing, conducted through simultaneous current–voltage measurements while heating the devices up to 250 °C, resulted in significant recovery. After four cycles of electro-thermal testing, the devices demonstrated significant improvements in performance, with a substantial recovery of on-current and a reduction in on-resistance compared to the post-radiation condition, approaching pre-radiation levels. Most recovery occurred during the first two cycles, with diminishing improvements thereafter, indicating that thermally responsive radiation-induced traps were largely mitigated early in the process. Capacitance–voltage measurements revealed a substantial reduction in net carrier concentration, decreasing from 3.2 × 1016 cm−3 pre-radiation to 5.5 × 1015 cm−3 after the first electro-thermal testing cycle, indicating an over 82% reduction. Following the third cycle, the carrier concentration partially recovered to 9.9 × 1015 cm−3, reflecting a carrier removal rate of ∼22 cm−1. The breakdown voltage (Vbr) exhibited a remarkable enhancement, increasing from approximately 300 V to 1.28 kV (a ∼325% improvement) after the first electro-thermal testing, which can be attributed to the reduction in net carrier concentration by compensating radiation-induced traps. Subsequent testing reduced Vbr slightly to 940 V due to partial recovery of carrier concentration, but it remained significantly higher than pre-radiation levels. These findings demonstrate the potential of combining neutron irradiation with electro-thermal annealing to significantly enhance the voltage-blocking capability of β-Ga2O3 power devices, making them strong candidates for high-power applications in radiation-intense environments. 

A systematic investigation of the electrical characteristics of β-Ga2O3 Schottky barrier diodes (SBDs) has been conducted under high-dose 60Co gamma radiation, with total cumulative doses reaching up to 5 Mrad (Si). Initial exposure of the diodes to 1 Mrad resulted in a significant decrease in on-current and an increase in on-resistance compared to the pre-radiation condition, likely due to the generation of radiation-induced deep-level acceptor traps. However, upon exposure to higher gamma radiation doses of 3 and 5 Mrad, a partial recovery of the device performance occurred, attributed to a radiation annealing effect. Capacitance–voltage (C–V) measurements showed a decrease in net carrier concentration in the β-Ga2O3 drift layer, from ∼3.20 × 1016 to ∼3.05 × 1016 cm−3, after 5 Mrad irradiation. Temperature-dependent I–V characteristics showed that 5 Mrad irradiation leads to a reduction in both forward and reverse currents across all investigated temperatures ranging from 25 to 250 °C, accompanied by slight increases in on-resistance, ideality factors, and Schottky barrier heights. Additionally, a slight increase in reverse breakdown voltage was observed post-radiation. Overall, β-Ga2O3 SBDs exhibit high resilience to gamma irradiation, with performance degradation mitigated by radiation-induced self-recovery, highlighting its potential for radiation-hardened electronic applications in extreme environment. 

We report on the growth of Si-doped homoepitaxial β-Ga2O3 thin films on (010) Ga2O3 substrates via metal-organic chemical vapor deposition (MOCVD) utilizing triethylgallium (TEGa) and trimethylgallium (TMGa) precursors. The epitaxial growth achieved an impressive 9.5 μm thickness at 3 μm/h using TMGa, a significant advance in material growth for electronic device fabrication. This paper systematically studies the Schottky barrier diodes fabricated on the three MOCVD-grown films, each exhibiting variations in the epilayer thickness, doping levels, and growth rates. The diode from the 2 μm thick Ga2O3 epilayer with TEGa precursor demonstrates promising forward current densities, the lowest specific on-resistance, and the lowest ideality factor, endorsing TEGa’s potential for MOCVD growth. Conversely, the diode from the 9.5 μm thick Ga2O3 layer with TMGa precursor exhibits excellent characteristics in terms of lowest leakage current, highest on-off ratio, and highest reverse breakdown voltage of −510 V without any electric field management, emphasizing TMGa’s suitability for achieving high growth rates in Ga2O3 epilayers for vertical power electronic devices. 

High crystalline quality thick β-Ga₂O₃drift layers are essential for multi-kV vertical power devices. Low-pressure chemical vapor deposition (LPCVD) is suitable for achieving high growth rates. This paper presents a systematic study of the Schottky barrier diodes fabricated on four different Si-doped homoepitaxial β-Ga₂O₃thin films grown on Sn-doped (010) and (001) β-Ga₂O₃substrates by LPCVD with a fast growth rate varying from 13 to 21  μm/h. A higher temperature growth results in the highest reported growth rate to date. Room temperature current density–voltage data for different Schottky diodes are presented, and diode characteristics, such as ideality factor, barrier height, specific on-resistance, and breakdown voltage are studied. Temperature dependence (25–250 °C) of the ideality factor, barrier height, and specific on-resistance is also analyzed from the J–V–T characteristics of the fabricated Schottky diodes.